The most straightforward way to unclog a toilet is to learn to use a flange plunger the right way. Flange plungers are designed specifically to clear toilet clogs. With a flange plunger, create a snug seal with both the flange and cup, and then plunge continuously for around twenty seconds. Read on to learn how to use your flange plunger to unclog a toilet properly. Here at Williams & Fogg Mechanical we are offering a step-by-step guide on how to plunge your toilet as effectively as possible. The next time your toilet clogs, look at these instructions to get everything flowing properly again in no time! If you are looking for a “plumber near me” in Richmond, call Williams & Fogg Mechanical for your emergency plumber needs today! 

 

How To Unclog Your Toilet

 

Let’s go through the best ways to unclog your toilet if it is a situation where you can do it yourself:

  • Use a flange- Flange plungers are specifically engineered for plunging toilets. The “flange” consists of an extended, sleeve-like rubber flap built into the underside of the plunger’s rubber cup. When you plunge a toilet, you insert this flange directly into the drain hole of the toilet bowl. This will result in a tighter seal than a conventional cup plunger is able to achieve and directs the suction generated by plunging directly into the drain below in order to unclog toilets more effectively. Also, make sure you’ve folded out (or extended) the flange from the cup before you start.
  • Prepare the area around the toilet- Plunging can get pretty messy, so be prepared. Slap on some rubber gloves and lay out towels or plastic wrap to catch spills. Get anything that you could knock over while working on the toilet out of the way. You should also wear boots or other gripping footwear in order to maintain good footing while you’re plunging away. 

 

Call An Emergency Plumber

 

More tips before you look for a “plumber near me”:

  • Level out the amount of water in the bowl- In order to maximize plunging effectiveness, you’ll want to fill the toilet bowl around halfway full with water in order to fully submerge the plunger cup. 
  • Place the flange into the toilet drain- Fit the flanger snugly into the top of the toilet bowl’s drain, insert the flange at an angle in order for the flap to fill with water as you lower it. This will assist in increasing suction and improving the plunge. After putting the flange in successfully, straighten the plunger again.
  • Fit the cup over the drain
  • Position and “test” your plunger seal
  • Plunge forcefully 5 to 6 times
  • Check water level in toilet bowl
  • Test to see if the clog is gone

 

Contact Us Today

 

If your toilet has ever overflowed, you know how stressful it is and how much you want to immediately get the problem solved. This is why it’s important to make sure that you have a basic knowledge of how to deal with a clogged toilet following the steps listed above. If you’re looking for a “plumber near me,” call Williams & Fogg Mechanical for your emergency plumber needs today!

Pin It on Pinterest

Share This