web analytics

A water heater is one of the most essential equipment in your home. It powers the fresh laundry, clean dishes, and hot showers. However, if it were to break, the clean comforts of home are gone and you’ve got an issue on your hands. With Williams & Fogg Mechanicals, we have you covered. Just type ‘a plumber near me’ and we’ll come tell you how to maintain your water heater in the event something like this happens. Richmond loves our services and we will make sure you have all the comforts of home!

Need Help? A Plumber Near Me Can Help!

The benefits of maintaining your water heater are clear. With these steps, it will save you time and money and avoid any issues in the future.

  • Drain the tank on a regular basis: it’s a good idea to flush out about ¼ of your water. Do this by turning off the cold water and hook up a garden hose to the value. Run the water until it is clear. Doing this step will clear the sediment build up and preserve the heating efficiency.
  • Check temperature: look for the thermostat on the water heater. Some manufacturers will automatically set the temperature to 140 Fahrenheit, which on average, is much hotter than you actually need. Any higher temperatures will cause scalding, and it will also build up corrosion. The recommended temperature should be 120 Fahrenheit. 
  • Test the relief valve for pressure: when working the valve, it should release hot water into the drainpipe after you lower the lever. Do this step regularly to clear any debris. If the water isn’t bursting every time, you will need to get a new pressure valve. 

Inexpensive Ways to Increase Efficiency

While there are several ways to avoid costs in maintenance, these extra steps will increase your water heater’s efficiency as well as longevity. Even the simple step of adding insulation only has to be done once. However, flushing the tank and checking the anode rod should be done on a regular basis.

  • Anode Rod: place a hose into the drain and let out at least a few gallons of water from the heater. You should use a 1 1/16-inch socket for the hex head, which is on top of the heater to unscrew the rod. When you remove it and you find it has build up of calcium, it’s time to buy a new one.
  • Insulating the pipes: invest in some self-sticking ⅜ inch foam that matches your pipes diameter. Slide the insulating over the pipes as far as you can reach.
  • Insulating the heater: a 4.5-covered bubble wrap blanket will suffice and you should wrap it around the pipes, TPR valve, and temperature control out of the tank.

Reach Us Today for any Concerns

Williams & Fogg Mechanical will answer any questions or concerns about your water heater and measures to take to keep it in mint condition. Just search “plumber near me” and contact us today. We’ll make sure all your heating needs are met and your equipment is functioning properly. Richmond loves our services, and we’ve got you covered.

Lowest Prices Guaranteed!

Pin It on Pinterest

Share This